I think it will work to remove the snap ring and lift it a bit and rotate. Posted 20:43 (#3529163 - in reply to #3529068) Subject: Re: Hesston 1160 hydroswing mower questions Posted 20:19 (#3529068 - in reply to #3529030) Subject: Re: Hesston 1160 hydroswing mower questions Posted 20:18 (#3529064 - in reply to #3529030) Subject: Re: Hesston 1160 hydroswing mower questions I guess I will find out when I pick it up! It was a last minute whim purchase. But that may be total width and not cutting width. In one photo, taken from about the same angle as the one you posted, there is what looks like a drawbar pin sticking in a hole. Posted 20:09 (#3529030 - in reply to #3528836) Subject: Re: Hesston 1160 hydroswing mower questions He might mean, it barely goes thru a 16 ft gate (meaning overall width ). Posted 19:43 (#3528956 - in reply to #3528941) Subject: Re: Hesston 1160 hydroswing mower questions Posted 19:40 (#3528941 - in reply to #3528937) Subject: Re: Hesston 1160 hydroswing mower questions I have a 1170 and it has been a good machine. I don't think so, there are two pieces of flat iron welded on the frame to stop the header so it will only swing so far from one side to the other. Posted 19:39 (#3528937 - in reply to #3528915) Subject: Re: Hesston 1160 hydroswing mower questions (Pivot of 1160 hesston_ in paint program.jpg) Attachments - Pivot of 1160 hesston_ in paint program.jpg (33KB - 248 downloads) I'm wondering, IF a guy could get head set on trailer, with head lowered then unhook rear swing cylinder completely, then remove that big snapring (I believe it is a snapring ), then WITHOUT removing any hoses, just lift/wiggle the entire tongue assembly upward, about 1-1.5" ( just high enough to miss "weldstops" ) and be able to almost turn the entire tongue 80-90 degrees, onto the trailer.
Looks to be roughly the same as 1014 (We own a 1014 ) I found a photo of a 1160, on the internet. Posted 19:33 (#3528915 - in reply to #3528836) Subject: RE: Hesston 1160 hydroswing mower questions It looks like this one will if I remove the cylinder? Or how hard is it to remove the tounge? I plan to haul it home sideways on a flat trailer and would like to know if the tounge will swing around enough so it is sticking straight off the back of the trailer? I had a 1014 hydroswing years ago and it wouldn't.
I bought a 16ft Hesston model 1160 hydroswing mower conditioner today in a online auction in Oklahoma. Posted 19:08 (#3528836) Subject: Hesston 1160 hydroswing mower questions Hesston 1160 hydroswing mower questions Jump to page : 1 Now viewing page 1
0 kommentar(er)
